Nav light refit kit (all-round / anchor light)
$322.95 complete kit
Ground shipping is $9.95 per order, added at checkout. Ships to the lower 48 states.
5 parts, picked to work together. Bring your own battery.
One part is out of stock right now. You can still add the other parts below.
Already own a part? Set it to 0 in the list below and add the rest.
Swap an old masthead or all-round light for a new Perko and rewire it properly: the light, 100 ft of 16/3 triplex cable, heat-shrink bullet plugs and ring terminals.
- $9.95 ground shipping, lower 48
- 30-day returns
- Secure checkout
- Specs from the maker
- Questions? 831-477-9600
Guides that help
Description
Swap an old masthead or all-round light for a new Perko and rewire it properly: the light, 100 ft of 16/3 triplex cable, heat-shrink bullet plugs and ring terminals.
Bring your own battery: these run off your 12V system.
Add all parts to cart. Already own a part? Set it to 0 below.
What’s in the box
| Qty | Part | What it does |
|---|---|---|
| 1 | Perko 12V combination masthead/all-round light | Perko 12V combination masthead / all-round light. Two compartments, 3 nm, for boats under 20 m, sail or power; two bulbs included (Perko). |
| 1 | Pacer Triplex cable 16/3, 100 ft | Tinned triplex boat cable, 16 AWG, 3 conductors, 100 ft. Room for a two-compartment light (masthead and all-round) plus its negative. Check the light’s wiring sheet. |
| 1 | Pacer Heat-shrink male bullet terminal 16-14 AWG, 100-pack | Heat-shrink male bullet terminals, 16-14 AWG, 100 per pack. For a light you can unplug. |
| 1 | Pacer Heat-shrink female bullet terminal 16-14 AWG, 100-pack | Heat-shrink female bullet terminals, 16-14 AWG, 100 per pack. The other half of the plug. |
| 1 | Pacer Heat-shrink ring terminal 16-14 AWG 1/4in, 100-pack | Heat-shrink ring terminals for 16-14 AWG wire, 1/4 inch stud, 100 per pack. |
Swaps on this page: Perko Fold-down combination masthead/all-round anchor light; Perko Stealth LED all-round, tower/arch mount; Perko Stealth LED all-round, fold-down vertical mount. Set the part you don’t need to 0 and the swap to 1.
Not in the box
- Sidelights (red and green)
- The blade fuse for the light circuit
- Mounting screws and sealant for your deck or arch
Who it’s for
Boat owners replacing a tired masthead / all-round white light. Sidelights (red and green) are not part of this kit, so keep your existing ones or add them separately.
Good fit if: Your boat is under 20 m and you’re replacing a tired masthead / all-round white light and rewiring it on its own fused circuit.
Not the pick if: You also need red and green sidelights: this kit covers only the white light, so keep your old ones or add them separately.
How it goes together
You can do this. Here’s how.
- Turn everything off and disconnect the battery, negative first.
- Unbolt the old light and pull its wire.
- Run the new cable from the fuse block to the light. Crimp bullet plugs where the light comes off, and ring terminals at the fuse block.
- Give the light its own fused circuit.
- Mount and seal the light, reconnect the battery (positive first, negative last), and check each compartment at the switch.
Read next: Fold-down all-round and anchor lights ยท Boat LED light amp draw
Fit rules
- Pick the light that matches your mount: plug-in pole (1124), fold-down (1184), tower or arch (1609), or fold-down vertical (1639). All are listed on this page.
- The 1124 and 1184 are combination masthead / all-round lights. The Stealth 1609 and 1639 are all-round only, so they don’t replace a combination light on a boat that needs a separate masthead light. (Perko)
- Nav lights must meet the visibility your boat’s length requires. Perko rates the 1124 at 3 nm and the Stealth lights at 2 nm, all for boats under 20 m. Check that against your boat before you buy.
- Each compartment of the 1124 draws about 0.8A at 12V (Perko gives 10 W), so 16 AWG is plenty on a normal run. Check longer runs with the wire gauge calculator.
- Give the light its own fused circuit on the fuse block.
Maker’s page: Perko 1123/1124
Questions
Does this cover all my nav lights?
No. This kit is for the white masthead / all-round light. You still need working red and green sidelights.
Why bullet terminals?
They let you unplug a light that lifts out or folds, and they make the light easy to swap later.
Is 100 ft too much cable?
Most refits use less. The rest is handy for the next run on the boat.
Each part ships from the maker’s distributor, so a kit can arrive in more than one box.
